Acer Network Device Altos R520 Manual de usuario descargar pdf (Pagina 147)

137

• If other software runs correctly on the system, contact your vendor

about the defective software.

No characters appear on the screen.

Check the following:

• Is the keyboard functioning? Test it by turning the “Num Lock”

function on and off to make sure the Num Lock light is

functioning.

• Is the video monitor plugged in and turned on? If you are using a

switch box, is it switched to the correct system?

• Are the brightness and contrast controls on the video monitor

properly adjusted?

• Is the video monitor signal cable properly installed?

• Does this video monitor work correctly if plugged into a different

system?

• Is the onboard video controller enabled in the BIOS setup?

• Remove all expansion cards and see if the system boots. If

successful, add the cards back in one at a time with a reboot

between each addition.

• Make sure the memory modules comply with the system

requirements.

• Make sure the memory modules have been populated according

to the system requirements.

• Remove and reseat the memory modules.

• Make sure the CPU comply with the system requirements.

• Make sure the CPU is populated according to the system

requirements.

If you are using a video controller board, do the following:

1 Verify that the video works using the onboard video controller.

2 Verify that the video controller board is fully seated in the

mainboard connector.

3 Reboot the system for changes to take effect.

4 If there are still no characters on the screen after you reboot the

system and POST emits a beep code, write down the beep code

you hear. This information is useful for your service representative.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 183 184

Sin comentarios

Acer Network Device Altos R520 Manual de usuario Pagina 147