Acer AB460 F1 Manual de usuario descargar pdf (Pagina 107)

100

101

Double-Wide Modules

Most modules in the AB7000 fit into single-wide bays. The InfiniBand

module and some other modules however (such as the 10GbE module),

require a double-wide bay and can only be installed in such a bay

created by combining the two right most bays. The enclosure's module

bays are designed to be easily modified from single to double-wide by

following the procedures below.

Setting up a Double-Wide Bay

Modifying an Enclosure’s Module Bays for Double-wide Modules

1. Remove the four screws that secure the inner enclosure to the

main enclosure. Slide the inner enclosure outward, depressing the

locking tabs on both sides to pull it completely out.

2. Remove any single-wide modules that are occupying the bays you

wish to modify to a double-wide bay.

3. In the module bay you wish to expand to double wide, remove the

two screws that secure the center support to the inner enclosure

then take out the center support. See Figure 2-53, Step 1 for

details.

4. Remove the two screws from the underside of each of the two

horizontal spacer (as shown in Figure 2-52). See Figure 2-53, Step 2

for details.

5. Using four screws, install the long horizontal spacer to the same

space where the two short spacer werse removed. See Figure 2-54,

Step 3 for details.

6. You can now install a double-wide module into the bay. See

Figure 2-54, Step 4 for details.

Note: This procedure describes modifying two right most single-

wide bays located at the top of the inner enclosure. The same

procedure applies to the two right most single bays located at the

bottom of the enclosure, but note that the horizontal spacer in

the bottom bays use a guide pin and are not interchangeable with

the upper bay spacers (see Figure 2-52 for details).

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 617 618

Comentarios a estos manuales

Sin comentarios

Acer AB460 F1 Manual de usuario Pagina 107

Comentarios a estos manuales