Acer PCI Disk Array Controller Drivers 08P4100 Manual de usuario descargar pdf (Pagina 22)

Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller

2-8 PCI Disk Array Controller Drivers Manual

☛ Note

In order to enable the CD-ROM boot, the controller’s

BIOS must be enabled.

4. If the controller’s BIOS is disabled, press <Enter> to enable the BIOS.

5. Use the arrow key to select “CD-ROM boot disabled” and press

<Enter> to enable the CD-ROM boot.

6. Press <ESC>, then press any key. This will restart the system with the

new settings.

The system will now boot from the NetWare 5.0 CD-ROM.

7. Return to the section “Installing NetWare 5.0 Drivers” and follow steps

4 through 7 to complete your driver installation.

Installing Peripherals Under NetWare 5.0

Non-disk peripheral devices, such as tape or CD-ROM drives, can be

installed on any channel of the controller. Each disk or non-disk device will

require a unique SCSI ID, different from any other device connected to the

channel.

Each device requires a driver module connecting it to the DAC adapter.

These modules are best loaded in the STARTUP.NCF file before the

MDAC.HAM driver.

The common devices and required modules are:

SCSI disk drives SCSIHD.CDM

(including Mylex

RAID system drives)

SCSI CD-ROM SCSICD.CDM

SCSI tape drive NWTAPE.CDM

Magneto optical drive SCSIMO.CDM

DLT ta pe drive DLT TA PE .CD M

IDE CD-ROM IDECD.CDM

IDE disk drive IDEHD.CDM

ASPI compliant NWASPI.CDM

applications such

as GAM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Sin comentarios

Acer PCI Disk Array Controller Drivers 08P4100 Manual de usuario Pagina 22