Acer PCI Disk Array Controller Drivers 08P4100 Manual de usuario descargar pdf (Pagina 80)

Installing the Mylex Disk Array Controller as the Secondary UnixWare Controller with UnixWare 2.1.2

6-8 Manual No. 775079

Installing the Mylex Disk Array Controller as the

Secondary UnixWare Controller with UnixWare

2.1.2

Mylex multifunction controllers use firmware 4.x or above. A special patch

is required for operation of these controllers with UnixWare 2.1.2 (not

required for UnixWare 7.x on x86 or UnixWare 2.1.3). UnixWare must

already be installed on another controller before you may install this special

patch. Follow the steps below to download the patch file and create a

diskette:

☛ Note

If you are installing UnixWare 7.x or UnixWare 2.1.3

as a secondary controller, please refer to “Installing the

Mylex Disk Array Controller as the Secondary

UnixWare Controller with UnixWare 7.x/2.1.3” on

page 6-5.

1. Download the following file from the Technical Support area of the

Mylex web site:

pcipatch.exe

2. Insert a non-bootable DOS-formatted floppy diskette in the diskette

drive and run:

pcipatch.exe a: ↵

Use the diskette you’ve just created when requested in the procedure below.

To install the UnixWare driver for the Mylex Disk Array Controller:

☛ Note

If installing onto a system that is SISL capable and

using a SISL capable DAC it is recommended to

disable the SCSI chip driver on the system by entering

the DCU at the appropriate screen then select

Software Device Drivers and disable the appropriate

driver.

1. Insert the patch diskette in the file server’s diskette drive.

2. Type the following (match case exactly as shown):

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Sin comentarios

Acer PCI Disk Array Controller Drivers 08P4100 Manual de usuario Pagina 80